Repair guide : Back Camera iPhone 7

Level : Medium Time : 35 min Author : Louis O.
150 people have done this repair successfully ! Why not you?

You cannot take pictures anymore with your iPhone 7 because the app is frozen, the pictures are blurry of the screen is black ? Do not panic, SOSav is here to help !Just follow this repair guide to fix your back camera. Do it yourself and save money !


Symptoms : 

  • Photo app does not open
  • Blurry pictures
  • Can't save videos
Some advice before you start
Repair - Repair guide: Back Camera iPhone 7
Guide format : Pdf Integrate

Step 1

Before disassembling the back camera of your iPhone 7, you have to securely turn it off.

Maintain the power button on the top for a few seconds.

Then slide to the right to "power off" button in red.

Your iPhone 7 is now turned off.

Step 2

With a pentalobe screwdriver, remove the two screws circled in red.

Those screws are on both sides of the dock connector.

Those two screws hold the bottom part of the display assembly to the iPhone.

Step 3

With a hairdryer, heat up the edge of the iPhone' screen as shown in red on picture 2.

This consists in peeling the seal between the screen and the rear panel.

Step 4

Then put the suction cups as near as possible to the home button.

Pull the cup enough to let a gap appear.

Put an opening pick between the display and rear case.

Step 5

Take a second opening pick and slide it around between the display and rear case.

Step 6

Start again on the right side.

Careful when sliding the pick because the screen connection cable are on this side.

Step 7

You can now open the iPhone by swinging the display up from the left side, like opening a book !

Step 8

Use the Triwing screwdriver, to remove the four screws circled in red on the picture.

Then with tweezers, remove the lower connector bracket

Step 9

The lower connector bracket is now removed.

Step 10

Use a nylon spudger to disconnect the display connector .

Step 11

Then unlock the second display connector.

Step 12

With a cruciform screwdriver, remove the two screws that maintain the front panel sensor assembly connector bracket.

Remove the bracket with tweezers.

Step 13

The bracket is now removed.

Step 14

Disconnect the proximity/front camera cable.

The complete display assembly is now removed from the iPhone 7.

Step 15

Disconnect the battery by lifting the connector from the logic board.

Step 16

Use a cruciform screwdriver to remove the two screws circled in red .

Those screws hold the back camera bracket.

Step 17

Use tweezers to grab and remove the camera.

Step 18

Use a nylon spudger to disconnect the back camera cable.

Step 19

Still using the spudger, remove the back camera from its socket.

Step 20

The back camera of your iPhone 7 is now disassembled.

If the quality of your pictures is bad, you can replace the back camera by a new one.

To reassemble your iPhone 7 follow this guide in reverse order.

Comments

Add a comment

They're talking about us

SOSav in the press

  • SOSav on tf1
  • SOSav on france 2
  • SOSav on france 3
  • SOSav on m6
  • SOSav on france info
  • SOSav on 01 net
  • SOSav on l express