Repair guide : WiFi Antenna iPhone 7

Level : Medium Time : 40 min Author : Louis O.
145 people have done this repair successfully ! Why not you?

Your iPhone 7 does not connect to WiFi at home or at work ? If this keeps happening wherever you go, if the WiFi is low or if it disconnect all the time, you better take this matter in your own hands ! 

Experts at SOSav will tell you how to replace your iPhone 7 defective WiFi antenna through this repair guidewhich comes with pictures and comments. Fixing your iPhone yourself is less expensive than having it fixed by a professional repairer so do not wait any longer !


Symptoms :

  • No WiFi network
  • unstable WiFi
  • WiFi cuts
  • Can't connect to WiFi
  • Low WiFi
Some advice before you start
Repair - Repair guide: WiFi Antenna iPhone 7
Guide format : Pdf Integrate

Step 1

Before disassembling the WiFi antenna of your iPhone 7, you have to securely turn it off.

Maintain the power button on the top for a few seconds.

Then slide to the right to "power off" button in red.

Your iPhone 7 is now turned off.

Step 2

With a pentalobe screwdriver, remove the two screws circled in red.

Those screws are on both sides of the dock connector.

Those two screws hold the bottom part of the display assembly to the iPhone.

Step 3

With a hairdryer, heat up the edge of the iPhone' screen as shown in red on picture 2.

This consists in peeling the seal between the screen and the rear panel.

Step 4

Then put the suction cups as near as possible to the home button.

Pull the cup enough to let a gap appear.

Put an opening pick between the display and rear case.

Step 5

Take a second opening pick and slide it around between the display and rear case.

Step 6

Start again on the right side.

Careful when sliding the pick because the screen connection cable are on this side.

Step 7

You can now open the iPhone by swinging the display up from the left side, like opening a book !

Step 8

Use the Triwing screwdriver, to remove the four screws circled in red on the picture.

Then with tweezers, remove the lower connector bracket

Step 9

The lower connector bracket is now removed.

Step 10

Use a nylon spudger to disconnect the display connector .

Step 11

Then unlock the second display connector.

Step 12

With a cruciform screwdriver, remove the two screws that maintain the front panel sensor assembly connector bracket.

Remove the bracket with tweezers.

Step 13

The bracket is now removed.

Step 14

Disconnect the proximity/front camera cable.

The complete display assembly is now removed from the iPhone 7.

Step 15

Disconnect the battery by lifting the connector from the logic board.

Step 16

Use a cruciform screwdriver to remove the two screws circled in red .

Those screws hold the back camera bracket.

Step 17

Use a pair of tweezers to grab and remove the back camera bracket.

Step 18

Use a nylon spudger to disconnect the back camera cable.

Step 19

Still using the spudger, remove the back camera from its socket.

Step 20

Remove the two cruciform screws circled in red.

Step 21

Disconnect the WiFi antenna cable with the spudger's tip.

Then lift the antenna to remove it.

Step 22

The WiFi antenna of your iPhone 7 is now disassembled.

You can replace it by a new one.

To reassemble your iPhone 7 follow this guide in reverse order.

Comments

Add a comment

They're talking about us

SOSav in the press

  • SOSav on tf1
  • SOSav on france 2
  • SOSav on france 3
  • SOSav on m6
  • SOSav on france info
  • SOSav on 01 net
  • SOSav on l express